Hello.. I am defining the hypoplastic parameters for Karlsruhe sand (found in a paper) using MIDAS GTS NX. In the software the a requesting (in addition of parameters) the number of internal state variables, and the number of integer indicator variables.
I know how to define 22 parameters, my issu is how to define the number of internal state variables and the number of integer indicator variables
Postdoctoral position at COFS, UWA 28.7.2025
Hypoplasticity clay in ABAQUS 23.7.2025
Drucker-Prager Cap 29.5.2025
Abaqus RITSS with hypoplastic 9.4.2025
Fellin UMAT subroutine 2.4.2025
Hypoplasticity clay for triaxial compression in abaqus 26.3.2025
Abaqus RITSS methon for LDFE analysis with hypoplastic 17.3.2025
Request for VUMAT Implementation of Mohr-Coulomb, Drucker-Prager, or Drucker-Prager Cap 28.2.2025
Suggestions for an Advanced Constitutive Model in FEM-Based Dynamic Slope Stability Analysis 12.2.2025
Hardening Soil or Hardening Soil-Small umat in Abaqus 2.1.2025
hypoplastic interface 11.12.2024
Triaxial Test Driver SANISAND 30.10.2024
©2026 SoilModels
I do not know Midas but according next link the umats from soilmodels are not compatible
http://manual.midasuser.com/en_common/GTS%20NX/150/GTS_NX/Appendix/USSR.htm
Thank you Arie..
I saw an old comment for you about definition of pore pressure as temperature.. may to know how to define the analogy between hydraulic and thermal conductivity ? What to define for specific heat..
QT=(T1-T2)*A*ktemp/L*dt [J]
ΔT=Q/VRCtemp
Qw= ΔhxAxkw/L*dt = (P1-P2)/9810xAxkw/L*dt [m3]
kw=m/s
ΔP=Qw/VxEwbulk
=> ktemp=conductility=Kw/9810
=> Ctemp=specified heat= 1/Ewbulk/R
Thank you Arie..
I really appreciate your help..
Thank you very very much again..
Dear Arie..
do you detailed document about this analogy?
could you please explain more about units and the definition of each term you mentioned because i am confused little bit
Thanks a lot
sorry.. do you have **