I want to consider particle crushing in the hypoplastic interface model. Also, when I use the CEL method to simulate, how can I use the hypoplastic interface model? Should I use VFRIC?
Related Articles
-
New book “Modelling of Soil Behaviour of Hypoplasticity”
I have just returned to Springer proofs of my new book “Modelling of Soil Behaviour of Hypoplasticity – Another Approach to Soil Constitutive Modelling“. It will probably still take few […] -
K0 determination Reloading using HP clay model
Hi Prof. Masin , It is related to my previous post. Sorry to bother you again. I simulated Oedometer test in Plaxis as well as centrifuge reloading (using HP clay […] -
Non-local regularization: Need VUMAT of Mohr-Coulomb model in abaqus
Dear Community, I want to include a non-local regularization technique in the built-in Mohr-Coulomb model of abaqus to capture the strain-localization effects. I am trying to find the original VUMAT […] -
Cyclic simple shear test simulation with hypoplasticity
Dear All, I am using sand hypoplastic model in my research and I have encountered some problem when looking into cyclic simple shear test in the range of small strains. […] -
Soft soil model vs Soft soil creep model
Soft soil and soft soil creep model both include time while performing the analysis. What is the difference between both of them. -
Modelling Rate-dependent behaviour of clay [Urgent]
Using PLAXIS, how to model rate dependent behavior of clay. This is to show the viscous behavior of the soil. Thank you in advance -
sand liquefaction modelling in Anura3D
Beginner level question for this forum – Trying to replace a Mohr-Coulomb model of sand in an Anura3D simulation with a material model which accurately describes sand liquefaction. References I’ve […] -
How to implement this Hypoplastic Interface Model into ABAQUS combined with the existing hypoplastic model subroutine
Hello: I’m a post-doc at the University of Nottingham, and I’m using the hypoplastic model to simulate the centrifuge tests we did. The research area is related to soil-pile interaction. […]
0 Comments
Supporting Organisations
Recent posts
-
Quality Whole Frozen Chicken & Parts for International Wholesale Buyers 4.9.2026
-
Animating Soil Mechanics 3.7.2026
-
GeoXPM 19.6.2026
-
Autumn School in Soil Modelling at NTNU 16.6.2026
-
Viscohypoplastic bentonite (VIBE) model 28.5.2026
-
Problem in “Hoek Brown Softening” Model 30.4.2026
-
XFEM Hydraulic Fracturing in Abaqus – Pore Pressure Not Updating & Extremely Small Time Steps 28.4.2026
-
Correct my Plaxis FEM simulation in foundation bearing capacity results 3.4.2026
-
mohr coulomb 2D yield surface vs 3D mohr coulomb yield surface 28.2.2026
-
Problem with GeoStudio (Seepage) software 16.2.2026
-
Prague Geotechnical Days 2026 3.2.2026
-
Postdoctoral position at COFS, UWA 28.7.2025