Hello all, I”m trying to simulate an axial cyclic loading in a drained soil using soil models like ISA hypoplasticity and SANISAND but for borh models the accumulated strain is way underestimated, could it be an issue in my simulation or the models don’t describe well the drained strain accumulation.
Thanks for your help
Related Articles
-
Question on the Matlab driver – model hypo Cam Clay
As a beginner to soil constitutive modelling, I am learning the hypoplastic models by reading the matlab drivers. I am confused with the matlab file f_hyp.m in the model hypo_camclay. […] -
Spurious oscillations in calculated accelerations
Hello everyone, I have just a general question how people approach the problem of spurious oscillations generated in dynamic analysis when using nonlinear soil constitutive models. I understand sometimes numerical […] -
Sanisand umat with BV problem
Hi, Does someone know if sanisand implementation has been used in a boundary value problem for slope? do you have any references? Thanks very much! -
Modelling TX monotonic compressive test with ABAQUS and SANISAND – not working
I am trying to reproduce a TX monotonic, compressive test on a sand by using a 1-element, axisymmetric ABAQUS FE model, assigned to a SANISAND material. For this purpose, I […] -
Calibration of the von Wolffersdorff model using Genetic Algorithms
I am happy to announce that our pre-print paper, “Calibration of the von Wolffersdorff model using Genetic Algorithms”, is available on researchgate: https://www.researchgate.net/publication/342198062_Calibration_of_the_von_Wolffersdorff_model_using_Genetic_Algorithms. In this article, we propose a novel […] -
Cyclic Behavior of Sand
Hello, Is there any constitutive model for sand which can simulate the number of cycles to reach the critical state. I used the SANISAND model but it is not promising. […] -
Cyclic/monotonic direct shear test (matlab driver)
Hi everyone, i am trying to simulate DSS/cDSS test in drained/undrained conditions and I was wondering how the constraints matrices should be ? while it is easy to understand how […] -
UMAT for strain-rate effects
Dear community, I’m interested in constitutive models that can handle strain-rate effects for HSR on sands for simulating free fall penetration. I would appreciate any help. Do you know any […]
0 Comments
Supporting Organisations
Recent posts
-
Viscohypoplastic bentonite (VIBE) model 28.5.2026
-
Problem in “Hoek Brown Softening” Model 30.4.2026
-
XFEM Hydraulic Fracturing in Abaqus – Pore Pressure Not Updating & Extremely Small Time Steps 28.4.2026
-
Correct my Plaxis FEM simulation in foundation bearing capacity results 3.4.2026
-
mohr coulomb 2D yield surface vs 3D mohr coulomb yield surface 28.2.2026
-
Problem with GeoStudio (Seepage) software 16.2.2026
-
Prague Geotechnical Days 2026 3.2.2026
-
Postdoctoral position at COFS, UWA 28.7.2025
-
Hypoplasticity clay in ABAQUS 23.7.2025
-
Drucker-Prager Cap 29.5.2025
-
Abaqus RITSS with hypoplastic 9.4.2025
-
Fellin UMAT subroutine 2.4.2025