I have a UMAT of Mohr Coulomb with no hardening, where i have to define SSE (specific strain energy) and SPD (specific plastic dissipation). Any idea?
Related Articles
-
-
UMAT in Geotechnics
Hi Everyone! I am a research Intern at Laval University, my project is about the effect of soil structure interaction on the seismic design of Geostructures. Exactly we want to […] -
Modelling Rate-dependent behaviour of clay [Urgent]
Using PLAXIS, how to model rate dependent behavior of clay. This is to show the viscous behavior of the soil. Thank you in advance -
Triaxial Callibration test with Hypoplasticity
Dear all I am trying to calibrate the HP for sand, and I have quite comprehensive data. but they are not totally consistent with each other . we have the […] -
FRIC code for clay hypoplasticity interface
Dear Prof Stutz and Prof Mašín, Is FRIC code for clay hypoplasticity available? If yes, could you please provide me with the link to download FRIC? Thank you Haran -
Shear Stiffness Calculation for Hypoplastic Model
Hi David, I have reproduced some single elements test on ABAQUS using the UMAT to compare with Triax Hypoplasticity. So far, my stiffness curve (q vs ea) and my stress […] -
Automatic calibration software ExCalibre has been launched
On behalf of the team of developers I am happy to announce that, after more than four years of development and testing, ExCalibre has just been launched. ExCalibre is a […] -
SaniSand Model in Plaxis 3D
Hello.. I am using SaniSand constitutive model, for the simulation of the behavior of onshore wind turbine using plaxis 3d. The dll file published in the website request the determination […]
Supporting Organisations
Recent posts
-
Problem in “Hoek Brown Softening” Model 30.4.2026
-
XFEM Hydraulic Fracturing in Abaqus – Pore Pressure Not Updating & Extremely Small Time Steps 28.4.2026
-
Correct my Plaxis FEM simulation in foundation bearing capacity results 3.4.2026
-
mohr coulomb 2D yield surface vs 3D mohr coulomb yield surface 28.2.2026
-
Problem with GeoStudio (Seepage) software 16.2.2026
-
Prague Geotechnical Days 2026 3.2.2026
-
Postdoctoral position at COFS, UWA 28.7.2025
-
Hypoplasticity clay in ABAQUS 23.7.2025
-
Drucker-Prager Cap 29.5.2025
-
Abaqus RITSS with hypoplastic 9.4.2025
-
Fellin UMAT subroutine 2.4.2025
-
Hypoplasticity clay for triaxial compression in abaqus 26.3.2025
Dear Matias,
I unfortunately can’t answer your question, but I’m asking you if you can provide me with the Mohr Coulomb UMAT if possible.
Thanks in advance.