I am trying to develop UMAT code for MCC, but facing difficulty. Is there any such files available which can help me to speed up.
please refer.
Thank you.
Related Articles
-
Hardening soil Model UMAT
I have the hardening soil model in the UMAT format. However, when I run the code, it gives me this error as shown in the picture. I tried to make […] -
Errors of sand hypoplastic model with Abaqus Vumat
Dear all, Recently, I have been working on the simulation of a pile-soil interaction with CEL method in Abaqus/Explicit. I simulate the sand with the Sand Hypoplasticity Model provided by […] -
Calibration Sand Hypoplasticity whit ExCalibre
Dear all I have some laboratory test of Pescara sand and I’m trying to find the von Wolffersdorff parameters of this sand. So I have used ExCalibre with the data […] -
Abaqus RITSS methon for LDFE analysis with hypoplastic
Hello everyone, I am using the ‘remeshing and interpolation technique with small strain’ (RITSS) method with hypoplastic, but I cannot continue the calculation after mapping. There is a warning in […] -
Velacs Project Data
Dear colleagues, I want to ask your help — does anyone know where we can find all the test data from the old Velacs Project? If so, that would be […] -
ERROR Message when using UMAT_hcea with ABAQUS
Hi all! I am modelling some triaxial compressions in ABAQUS with Weald Clay. The constitutive law i am using is the clay hypoplasticity by Mašín. When running the program using […] -
UMAT for Creep-SCLAY model.
Does anyone have the UMAT for the Creep-Clay model to be implemented in Abaqus? -
Cyclic/monotonic direct shear test (matlab driver)
Hi everyone, i am trying to simulate DSS/cDSS test in drained/undrained conditions and I was wondering how the constraints matrices should be ? while it is easy to understand how […]
Supporting Organisations
Recent posts
-
Correct my Plaxis FEM simulation in foundation bearing capacity results 3.4.2026
-
mohr coulomb 2D yield surface vs 3D mohr coulomb yield surface 28.2.2026
-
Problem with GeoStudio (Seepage) software 16.2.2026
-
Prague Geotechnical Days 2026 3.2.2026
-
Postdoctoral position at COFS, UWA 28.7.2025
-
Hypoplasticity clay in ABAQUS 23.7.2025
-
Drucker-Prager Cap 29.5.2025
-
Abaqus RITSS with hypoplastic 9.4.2025
-
Fellin UMAT subroutine 2.4.2025
-
Hypoplasticity clay for triaxial compression in abaqus 26.3.2025
-
Abaqus RITSS methon for LDFE analysis with hypoplastic 17.3.2025
-
Request for VUMAT Implementation of Mohr-Coulomb, Drucker-Prager, or Drucker-Prager Cap 28.2.2025
Hi, I am trying to do the MCC coding, too. If you have any good resource, could you share with me?
Thanks,
Shile.dong@ucdenver.edu
Hi, I am trying to do the MCC coding, too. If you have any good resource, could you share with me?
Thanks,
hhuzhangyuxian@163.com
Hi, do you have the UMAT format of MCC? can you share it with me? zahedip@tcd.ie