Dear fellow,
Anyone have SANISAND 2008 by Taiebat and Dafalias umat subroutine available for Abaqus. I have 2004 but I need 2008 one.
||Finite Elements|0 |
||Finite Elements|0 |
Related Articles
-
An error in the SANISAND umat runtime
Dear all I was simulating a pile in a fully drained soil subjected to horizontal loads using ABAQUS (as shown in Figure 1) and noticed from the monitor that the […] -
ABAQUS Mesh-to-mesh solution mapping with Modified Cam Clay
I am using the mesh-to-mesh solution mapping with MCC model. The element type used is CPE8RP. My initial analysis runs without any issue and when the deformations reach a certain […] -
UMAT for hypoplastic subroutine
Hello all, Could you please anyone provide me umat for Hypoplastic model that used as subroutine in Abqus 6.14. With Best Regards Naif Mohammed -
UMAT Implementation in Abaqus (Hypoplastic clay Subroutines)
Hi, I am working in Abaqus, aiming to model double porosity clay consolidation data by using hypoplastic clay model with meta stable structure. First, i just wanted to verify basic […] -
Plaxis 3D Tunnel
Hi Everybody, I would like to ask an error problem where I am getting while using Plaxis 3D tunnel V 1.2. Previously I was using the software with Windows 7 […] -
Issue in applying SANISAND04 UMAT to Boundary-Value-Problem
Hi All, I am currently working on a research problem involving the implementation of the SANISAND04 UMAT (Soil models) in Abaqus for embankment analysis. While I have successfully tested the […] -
Transient Dynamic analysis (U-P formulation)
Hi everyone, i want to carry out some transient dynamic analysis. as far as I know, dynamic steps in abaqus does not allow for pore pressure build-up and dissipation, and […] -
Problem with Hypoplastic Vumat use with CEL in Abaqus
Hello all, I am currently working on the FE modeling of anchors installation into the soil using the CEL analysis in Abaqus. I tried to use the hypoplastic vumat for […]
0 Comments
Supporting Organisations
Recent posts
-
Drucker-Prager Cap 29.5.2025
-
Abaqus RITSS with hypoplastic 9.4.2025
-
Fellin UMAT subroutine 2.4.2025
-
Hypoplasticity clay for triaxial compression in abaqus 26.3.2025
-
Abaqus RITSS methon for LDFE analysis with hypoplastic 17.3.2025
-
Request for VUMAT Implementation of Mohr-Coulomb, Drucker-Prager, or Drucker-Prager Cap 28.2.2025
-
Suggestions for an Advanced Constitutive Model in FEM-Based Dynamic Slope Stability Analysis 12.2.2025
-
Hardening Soil or Hardening Soil-Small umat in Abaqus 2.1.2025
-
hypoplastic interface 11.12.2024
-
Triaxial Test Driver SANISAND 30.10.2024
-
REQUEST FOR EXPRESSIONS OF INTEREST (REOI) FOR PROJECT IN CONSTITUTIVE MODELLING 23.10.2024
-
Programme of the ALERT Olek Zienkiewicz school on Constitutive Modelling of Geomaterials, February 3 to 7, 2025, Prague, Czech Republic 11.10.2024