Does anyone have the UMAT for the Creep-Clay model to be implemented in Abaqus?
Related Articles
-
Hypoplastic Interface Model: Does anybody implemented this model in FLAC3D
I want to use this model to simulate soil-structure interaction in FLAC3D software, so I was wondering does anybody implemented this model in FLAC3D, and could you please share your […] -
-
Error: permission to access files denied (Hypoplasticity in PLAXIS)
Hello, I am trying to implement the dll for hypoplasticity in Plaxis 3D. It runs through both the Initial Phase and a Nil Step. However, when it calculates about 20 […] -
The GA-cal software for the automatic calibration of soil constitutive laws
I am happy to announce that our pre-print paper, “The GA-cal software for the automatic calibration of soil constitutive laws: a tutorial and a user manual”, is available on researchgate […] -
Rate dependent plastic yield in Tochnog Question
Hi, I am new to Tochnog and really appreciate the open source modeling chain (gmsh->Tochnog->paraview). So far, I’m only familiar with commercial codes, e.g. Abaqus. I actually deal with metal […] -
Triaxial Test Driver SANISAND
I cannot find sanisand in the library of available constitutive models for the triaxial test driver, even if it is listed as one of the available models on the main […] -
Interpreting results of sand hypoplastic model with Abaqus VUMAT
Dear concern, Recently i have modelled the soil pile interaction using Abaqus CEL method. The hypoplastic behavior of the soil is model using user subroutine VUMAT. The properties of the […] -
Vumat to calculate excess pore in Coupled Eulerian-Lagrangian ABAQUS
Hi folks, May I know Is there a useable VUMAT in soilmodels.com that follows the framework of Grabe and Hamann? I need the VUMAT to calculate excess pore pressure in […]
0 Comments
Supporting Organisations
Recent posts
-
Problem in “Hoek Brown Softening” Model 30.4.2026
-
XFEM Hydraulic Fracturing in Abaqus – Pore Pressure Not Updating & Extremely Small Time Steps 28.4.2026
-
Correct my Plaxis FEM simulation in foundation bearing capacity results 3.4.2026
-
mohr coulomb 2D yield surface vs 3D mohr coulomb yield surface 28.2.2026
-
Problem with GeoStudio (Seepage) software 16.2.2026
-
Prague Geotechnical Days 2026 3.2.2026
-
Postdoctoral position at COFS, UWA 28.7.2025
-
Hypoplasticity clay in ABAQUS 23.7.2025
-
Drucker-Prager Cap 29.5.2025
-
Abaqus RITSS with hypoplastic 9.4.2025
-
Fellin UMAT subroutine 2.4.2025
-
Hypoplasticity clay for triaxial compression in abaqus 26.3.2025