Dear all,
I’m looking for a sigini and sdvini subroutine examples to calculate soil initial state with rest coeficient K0 method or ICP-05 method or any method available.
thank you.
Best regards.
||Finite Elements|0 |
||Finite Elements|0 |
Related Articles
-
problem with sanisand umat
Dear all, I’m trying to model multilayer soil in abaqus. To use the SaniSand umat in model I use the following parameters but no plastic strain at all. The unit […] -
Modeling of granular soil by using UMAT hypoplastic in Abaqus
Dear all I am using the UMAT of hypoplastic model for simulation soil (3D modeling) under cyclic loading. The analysis was completed at geostatic step. But for consolidation step (soil, […] -
Slope stability calculation with hypoplasticity using phi-c reduction available now in download section
The strength reduction method in clay hypoplasticity now available -
Interface to study soil-structure interaction in Plaxis 3D (Clay Hypoplasticity)
Hello, I am trying to simulate the behavior of helical anchors (also called screw anchors) using PLAXIS 3D and a clay hypoplasticity constitutive model. The helical anchor shaft is simulated […] -
Problem in calculating Lateral displacement of the pile using Hypoplastic clay model
Hy Professor David, I am trying to verify the result of one of your paper by the title ‘Cyclic lateral response and failure mechanisms of semi-rigid pile in soft clay: […] -
Consolidation analysis using HP clay model in Plaxis
Dear Prof David / SOil model community, I am performing coupled consolidation analysis for deep excavation in clay using HP clay model in Plaxis 3D. Performing the undrained analysis, the […] -
Small displacements when using HP model in Plaxis 3D
I am modelling sand slopes in Plaxis 3D using an HP model. I am using soil parameters from “Modelling of Soil Behaviour with Hypoplasticity” by David Masin (2019). During the […] -
Hypoplasticity clay for triaxial compression in abaqus
While performing drained triaxial compression tests on hypoplastic clay using ABAQUS, I observed that the specimen’s porosity remains constant. Additionally, I have questions regarding the application of the material parameter […]
0 Comments
Supporting Organisations
Recent posts
-
Postdoctoral position at COFS, UWA 28.7.2025
-
Hypoplasticity clay in ABAQUS 23.7.2025
-
Drucker-Prager Cap 29.5.2025
-
Abaqus RITSS with hypoplastic 9.4.2025
-
Fellin UMAT subroutine 2.4.2025
-
Hypoplasticity clay for triaxial compression in abaqus 26.3.2025
-
Abaqus RITSS methon for LDFE analysis with hypoplastic 17.3.2025
-
Request for VUMAT Implementation of Mohr-Coulomb, Drucker-Prager, or Drucker-Prager Cap 28.2.2025
-
Suggestions for an Advanced Constitutive Model in FEM-Based Dynamic Slope Stability Analysis 12.2.2025
-
Hardening Soil or Hardening Soil-Small umat in Abaqus 2.1.2025
-
hypoplastic interface 11.12.2024
-
Triaxial Test Driver SANISAND 30.10.2024